Authorized Demag and KBK dealer · Engineering by a licensed PE (276) 582-1970 · Mon–Fri 8:00–4:00
EZUP Crane Systems EZUP Crane Systems
EZUP workstation cranes

Motorized in every motion. Radio controlled as standard.

EZUP cranes pick up where typical workstation cranes stop: up to 3 tons, bridge spans to 60 feet, and powered bridge, trolley and hoist travel on every system.

Request a Quote
Complete EZUP 3 ton crane with yellow bridge, red trolley and orange conductor bar on shop stands
Two lines

Industrial and Professional.

Pick the line by duty and the power you have. Both use the same engineering behind them.

EZUP IndustrialEZUP Professional
CapacityUp to 3 t1 t and under
Bridge spanUp to 60 ftShorter spans, by application
Power3-phase, 230 or 480 V120 V single phase
TravelMotorized bridge and trolley, variable speedMotorized or push-pull
ControlIndustrial radio, two transmittersPendant or radio
HoistDemag DC-Pro chain hoistDemag DC-Com chain hoist
Best forPlants with heavy or high-cycle liftingSmall shops, maintenance and repair
EZUP advantages

Well engineered and easy to maintain.

Black worm-gear speed reducer and motor driving an EZUP end truck
Worm-gear drive on an EZUP end truck

Heavy-duty wheel blocks

Solid steel wheels with 70D polyurethane treads give smooth, quiet travel for years.

Worm-gear drives, no brakes

Industrial motors and worm gearboxes hold position. There are no brake pads to adjust or replace.

Radio control standard

Industrial radio with two transmitters, so the operator stands clear of the load.

Variable speed

VFD bridge and trolley controls cut load swing. Simple controls are easy to repair.

Best hook height

Low-clearance design as standard, and no power or control wires hanging down.

Clean power feed

Enclosed conductor bar runs along the bridge and runway.

Usually no foundation

With at least a 4 in. concrete slab, you will likely not need new footings. We evaluate your floor first.

Lifetime warranty

On all structural and mechanical components. Electrical components carry one year; hoists carry the manufacturer's warranty.

EZUP bridge end truck with control enclosure and orange conductor bar along the girder
Bridge end truck, control panel and conductor bar
From inquiry to load test

How an EZUP system goes in.

  1. Layout

    You give us the load, coverage area and clear height. We lay out the bridge and runway.

  2. Engineering check

    Our PE checks the slab or the building structure the system hangs from.

  3. Fabrication

    Steel is fabricated and the components are assembled and wired in the shop.

  4. Installation

    Our crew or a qualified local installer sets the runway and bridge.

  5. Load test

    The crane is load tested and you receive a load test certificate.

In the shop and in the field

EZUP cranes at work.

EZUP 3 ton bridge with nameplate and red trolley in the fabrication shop
Serial no. 17006, final assembly
Yellow EZUP bridge girders bolted to the end truck
Bolted girder-to-end-truck connection
Double-girder EZUP 3 ton crane installed under a warehouse roof
Low-headroom installation under roof framing
EZUP 3 ton bridge spanning a machining bay
Serial no. 19001 over a machining bay
EZUP end truck riding a gray free-standing runway beam
End truck on a free-standing runway
Close view of an EZUP end truck corner with rubber bumper and guide
End truck corner with bumper

Size an EZUP crane for your bay.

Send the load, span and runway length. We will reply with a layout and budget price.

Request a Quote